Merge pull request #3324 from tnw513/fix_filament_dia

changed DEFAULT_NOMINAL_FILAMENT_DIA for consistency between example config files

Marlin/example_configurations/Hephestos_2/Configuration.h

@@ -919,7 +919,7 @@ const bool Z_MIN_PROBE_ENDSTOP_INVERTING = false; // set to true to invert the l
 // Uncomment below to enable
 //#define FILAMENT_WIDTH_SENSOR
 
-#define DEFAULT_NOMINAL_FILAMENT_DIA 1.75  //Enter the diameter (in mm) of the filament generally used (3.0 mm or 1.75 mm) - this is then used in the slicer software.  Used for sensor reading validation
+#define DEFAULT_NOMINAL_FILAMENT_DIA 3.00  //Enter the diameter (in mm) of the filament generally used (3.0 mm or 1.75 mm) - this is then used in the slicer software.  Used for sensor reading validation
 
 #if ENABLED(FILAMENT_WIDTH_SENSOR)
   #define FILAMENT_SENSOR_EXTRUDER_NUM 0   //The number of the extruder that has the filament sensor (0,1,2)

Marlin/example_configurations/delta/biv2.5/Configuration.h

@@ -1051,7 +1051,7 @@ const bool Z_MIN_PROBE_ENDSTOP_INVERTING = true; // set to true to invert the lo
 // Uncomment below to enable
 //#define FILAMENT_WIDTH_SENSOR
 
-#define DEFAULT_NOMINAL_FILAMENT_DIA 1.75  //Enter the diameter (in mm) of the filament generally used (3.0 mm or 1.75 mm) - this is then used in the slicer software.  Used for sensor reading validation
+#define DEFAULT_NOMINAL_FILAMENT_DIA 3.00  //Enter the diameter (in mm) of the filament generally used (3.0 mm or 1.75 mm) - this is then used in the slicer software.  Used for sensor reading validation
 
 #if ENABLED(FILAMENT_WIDTH_SENSOR)
   #define FILAMENT_SENSOR_EXTRUDER_NUM 0   //The number of the extruder that has the filament sensor (0,1,2)

Marlin/example_configurations/delta/kossel_xl/Configuration.h

@@ -958,7 +958,7 @@ const bool Z_MIN_PROBE_ENDSTOP_INVERTING = false; // set to true to invert the l
 // Uncomment below to enable
 //#define FILAMENT_WIDTH_SENSOR
 
-#define DEFAULT_NOMINAL_FILAMENT_DIA 1.75  //Enter the diameter (in mm) of the filament generally used (3.0 mm or 1.75 mm) - this is then used in the slicer software.  Used for sensor reading validation
+#define DEFAULT_NOMINAL_FILAMENT_DIA 3.00  //Enter the diameter (in mm) of the filament generally used (3.0 mm or 1.75 mm) - this is then used in the slicer software.  Used for sensor reading validation
 
 #if ENABLED(FILAMENT_WIDTH_SENSOR)
   #define FILAMENT_SENSOR_EXTRUDER_NUM 0   //The number of the extruder that has the filament sensor (0,1,2)