You cannot select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
Scott Lahteine 18dd5cb46a Config comment patch 5 years ago
..
DUAL Tweak REPRAPWORLD_KEYPAD config comment 5 years ago
Configuration.h Tweak REPRAPWORLD_KEYPAD config comment 5 years ago
Configuration_adv.h Config comment patch 5 years ago
README.md Relocate configs above Marlin/src folder (#13299) 6 years ago

README.md

Felix 2.0/3.0 Configuration for Marlin Firmware

Bringing silky smooth prints to Felix.

Build HOWTO

cd Marlin/src
cp config/examples/Felix/Configuration_adv.h .

The next step depends on your setup:

Single Extruder Configuration

cp config/examples/Felix/Configuration.h .

Dual Extruder Configuration

cp config/examples/Felix/DUAL/Configuration.h Configuration.h

Compile Firmware

  • Start the Arduino IDE.
  • Select Tools -> Board -> Arduino Mega 2560
  • Select the correct serial port in Tools -> Serial Port (usually /dev/ttyUSB0)
  • Open Marlin.pde or .ino
  • Click the Verify/Compile button

Flash Firmware

Connected directly via USB

  • Click the Upload button. If all goes well the firmware is uploading

Remote update

Find the latest Arduino build:

ls -altr /tmp/
drwxr-xr-x 5 chrono users 12288 Mar 3 21:41 build6072035599686630843.tmp

Copy the firmware to your printer host:

scp /tmp/build6072035599686630843.tmp/Marlin.cpp.hex a.b.c.d:/tmp/

Connect to your printer host via ssh, stop Octoprint or any other service that may block your USB device and make sure you have avrdude installed, then run:

avrdude -C/etc/avrdude.conf -v -v -v -patmega2560 -cwiring -P/dev/ttyUSB0 \
-b115200 -D -Uflash:w:/tmp/Marlin.cpp.hex:i

Acknowledgements

Mashed together and tested on https://apollo.open-resource.org/mission:resources:picoprint based on collaborative teamwork of @andrewsil1 and @thinkyhead.