From 3a27a78f9ed5c89735ace99d8c4173991f3405a4 Mon Sep 17 00:00:00 2001 From: AnHardt Date: Mon, 20 Apr 2015 15:01:43 +0200 Subject: [PATCH] Commented REPRAP_DISCOUNT_SMART_CONTROLLER again and removed some tabs. --- Marlin/Configuration.h | 14 +++++++------- 1 file changed, 7 insertions(+), 7 deletions(-) diff --git a/Marlin/Configuration.h b/Marlin/Configuration.h index 81392d96b..4e39703ad 100644 --- a/Marlin/Configuration.h +++ b/Marlin/Configuration.h @@ -680,7 +680,7 @@ const bool Z_PROBE_ENDSTOP_INVERTING = false; // set to true to invert the logic // The RepRapDiscount Smart Controller (white PCB) // http://reprap.org/wiki/RepRapDiscount_Smart_Controller -#define REPRAP_DISCOUNT_SMART_CONTROLLER +//#define REPRAP_DISCOUNT_SMART_CONTROLLER // The GADGETS3D G3D LCD/SD Controller (blue PCB) // http://reprap.org/wiki/RAMPS_1.3/1.4_GADGETS3D_Shield_with_Panel @@ -791,13 +791,13 @@ const bool Z_PROBE_ENDSTOP_INVERTING = false; // set to true to invert the logic // Uncomment below to enable //#define FILAMENT_SENSOR -#define FILAMENT_SENSOR_EXTRUDER_NUM 0 //The number of the extruder that has the filament sensor (0,1,2) -#define MEASUREMENT_DELAY_CM 14 //measurement delay in cm. This is the distance from filament sensor to middle of barrel +#define FILAMENT_SENSOR_EXTRUDER_NUM 0 //The number of the extruder that has the filament sensor (0,1,2) +#define MEASUREMENT_DELAY_CM 14 //measurement delay in cm. This is the distance from filament sensor to middle of barrel -#define DEFAULT_NOMINAL_FILAMENT_DIA 3.0 //Enter the diameter (in mm) of the filament generally used (3.0 mm or 1.75 mm) - this is then used in the slicer software. Used for sensor reading validation -#define MEASURED_UPPER_LIMIT 3.30 //upper limit factor used for sensor reading validation in mm -#define MEASURED_LOWER_LIMIT 1.90 //lower limit factor for sensor reading validation in mm -#define MAX_MEASUREMENT_DELAY 20 //delay buffer size in bytes (1 byte = 1cm)- limits maximum measurement delay allowable (must be larger than MEASUREMENT_DELAY_CM and lower number saves RAM) +#define DEFAULT_NOMINAL_FILAMENT_DIA 3.0 //Enter the diameter (in mm) of the filament generally used (3.0 mm or 1.75 mm) - this is then used in the slicer software. Used for sensor reading validation +#define MEASURED_UPPER_LIMIT 3.3 //upper limit factor used for sensor reading validation in mm +#define MEASURED_LOWER_LIMIT 1.9 //lower limit factor for sensor reading validation in mm +#define MAX_MEASUREMENT_DELAY 20 //delay buffer size in bytes (1 byte = 1cm)- limits maximum measurement delay allowable (must be larger than MEASUREMENT_DELAY_CM and lower number saves RAM) //defines used in the code #define DEFAULT_MEASURED_FILAMENT_DIA DEFAULT_NOMINAL_FILAMENT_DIA //set measured to nominal initially